Back to test-mbed-drivers-reset-reason Results ^
Target: NUCLEO_H563ZI
Test: test-mbed-drivers-reset-reason
Test Case: test-mbed-drivers-reset-reason
[1/1] Flashing test-mbed-drivers-reset-reason with STM32CubeProg...
-------------------------------------------------------------------
STM32CubeProgrammer v2.18.0
-------------------------------------------------------------------
libusb: warning [libusb_exit] device 8.1 still referenced
libusb: warning [libusb_exit] device 7.9 still referenced
libusb: warning [libusb_exit] device 7.8 still referenced
libusb: warning [libusb_exit] device 7.7 still referenced
libusb: warning [libusb_exit] device 7.6 still referenced
libusb: warning [libusb_exit] device 7.1 still referenced
libusb: warning [libusb_exit] device 6.1 still referenced
libusb: warning [libusb_exit] device 5.1 still referenced
libusb: warning [libusb_exit] device 2.1 still referenced
libusb: warning [libusb_exit] device 1.8 still referenced
libusb: warning [libusb_exit] device 1.6 still referenced
libusb: warning [libusb_exit] device 1.10 still referenced
libusb: warning [libusb_exit] device 1.4 still referenced
libusb: warning [libusb_exit] device 1.3 still referenced
libusb: warning [libusb_exit] device 1.2 still referenced
libusb: warning [libusb_exit] device 1.11 still referenced
libusb: warning [libusb_exit] device 1.9 still referenced
libusb: warning [libusb_exit] device 1.7 still referenced
libusb: warning [libusb_exit] device 1.5 still referenced
libusb: warning [libusb_exit] device 1.1 still referenced
libusb: warning [libusb_exit] device 4.2 still referenced
libusb: warning [libusb_exit] device 4.1 still referenced
libusb: warning [libusb_exit] device 3.3 still referenced
libusb: warning [libusb_exit] device 3.2 still referenced
libusb: warning [libusb_exit] device 3.1 still referenced
ST-LINK SN : 003300413133511437363734
ST-LINK FW : V3J10M3
Board : NUCLEO-H563ZI
Voltage : 3.27V
Warning: Connection to AP 0 requested and failed, Connection established with AP 1
SWD freq : 8000 KHz
Connect mode: Under Reset
Reset mode : Hardware reset
Device ID : 0x484
Revision ID : Rev X
Device name : STM32H56x/573
Flash size : 2 MBytes
Device type : MCU
Device CPU : Cortex-M33
BL Version : 0xE4
SFSP Version: v2.5.0
Debug in Low Power mode enabled
Opening and parsing file: test-mbed-drivers-reset-reason.bin
Memory Programming ...
File : test-mbed-drivers-reset-reason.bin
Size : 68.55 KB
Address : 0x08000000
Erasing memory corresponding to segment 0:
Erasing internal memory sectors [0 8]
Download in Progress:
[=========================================== ] 86% [==================================================] 100%
File download complete
Time elapsed during download operation: 00:00:00.277
MCU Reset
Software reset is performed
Executing: /home/jamie/Mbed/mbed-os/venv/bin/python3 -m mbed_host_tests.mbedhtrun --skip-flashing -p /dev/ttyNUCLEO_H563ZI --skip-reset -e /home/jamie/Mbed/mbed-os/drivers/tests/TESTS/host_tests -m NUCLEO_H563ZI --baud-rate=115200
[+338ms][HTST][INF] host test executor ver. 0.0.16
[+338ms][HTST][INF] copy image onto target... SKIPPED!
[+339ms][HTST][INF] starting host test process...
[+342ms][CONN][INF] starting connection process...
[+342ms][CONN][INF] notify event queue about extra 60 sec timeout for serial port pooling
[+342ms][CONN][INF] initializing serial port listener...
[+342ms][SERI][INF] using specified port '/dev/ttyNUCLEO_H563ZI'
[+342ms][SERI][INF] serial(port=/dev/ttyNUCLEO_H563ZI, baudrate=115200, read_timeout=0.01, write_timeout=5)
[+343ms][HTST][INF] setting timeout to: 60 sec
[+345ms][SERI][TXD] mbedmbedmbedmbedmbedmbedmbedmbedmbedmbed
[+345ms][CONN][INF] sending up to 2 __sync packets (specified with --sync=2)
[+345ms][CONN][INF] sending preamble '3416a8c1-1fba-4f2f-82e9-2856d7329f09'
[+349ms][SERI][TXD] {{__sync;3416a8c1-1fba-4f2f-82e9-2856d7329f09}}
[+359ms][CONN][RXD] mbedmbedmbedmbedmbedmbedmbedmbed
[+369ms][CONN][INF] found SYNC in stream: {{__sync;3416a8c1-1fba-4f2f-82e9-2856d7329f09}} it is #0 sent, queued...
[+369ms][CONN][INF] found KV pair in stream: {{__version;1.3.0}}, queued...
[+369ms][CONN][INF] found KV pair in stream: {{__timeout;90}}, queued...
[+369ms][CONN][INF] found KV pair in stream: {{__host_test_name;reset_reason}}, queued...
[+369ms][HTST][INF] sync KV found, uuid=3416a8c1-1fba-4f2f-82e9-2856d7329f09, timestamp=1736405058.759621
[+370ms][CONN][INF] found KV pair in stream: {{ready;0000000a,0}}, queued...
[+370ms][HTST][INF] DUT greentea-client version: 1.3.0
[+370ms][HTST][INF] setting timeout to: 90 sec
[+370ms][HTST][INF] host test class: ''
[+370ms][HTST][INF] host test setup() call...
[+370ms][HTST][INF] CALLBACKs updated
[+370ms][HTST][INF] host test detected: reset_reason
[+380ms][SERI][TXD] {{reason_raw;get}}
[+390ms][CONN][INF] found KV pair in stream: {{reason_raw;0c000000}}, queued...
[+401ms][SERI][TXD] {{reason;get}}
[+412ms][CONN][INF] found KV pair in stream: {{reason;2}}, queued...
[+422ms][SERI][TXD] {{reason;clear}}
[+433ms][CONN][INF] found KV pair in stream: {{reason;cleared}}, queued...
[+443ms][SERI][TXD] {{reset;nvic}}
[+454ms][CONN][INF] found KV pair in stream: {{reset;ack}}, queued...
[+1459ms][SERI][TXD] {{__sync;0}}
[+1470ms][CONN][RXD] mbedmbedmbedmbedmbedmbedmbedmbed
[+1470ms][CONN][INF] found KV pair in stream: {{__sync;0}}, queued...
[+1470ms][CONN][INF] found KV pair in stream: {{__version;1.3.0}}, queued...
[+1470ms][CONN][INF] found KV pair in stream: {{__timeout;90}}, queued...
[+1471ms][HTST][ERR] orphan event in main phase: {{__sync;0}}, timestamp=1736405059.859841
[+1471ms][HTST][ERR] orphan event in main phase: {{__version;1.3.0}}, timestamp=1736405059.859856
[+1471ms][HTST][ERR] orphan event in main phase: {{__timeout;90}}, timestamp=1736405059.859864
[+1481ms][CONN][INF] found KV pair in stream: {{__host_test_name;reset_reason}}, queued...
[+1481ms][CONN][INF] found KV pair in stream: {{ready;0000000a,0}}, queued...
[+1481ms][HTST][ERR] orphan event in main phase: {{__host_test_name;reset_reason}}, timestamp=1736405059.870751
[+1492ms][SERI][TXD] {{reason_raw;get}}
[+1502ms][CONN][INF] found KV pair in stream: {{reason_raw;14000000}}, queued...
[+1513ms][SERI][TXD] {{reason;get}}
[+1523ms][CONN][INF] found KV pair in stream: {{reason;3}}, queued...
[+1534ms][SERI][TXD] {{reason;clear}}
[+1544ms][CONN][INF] found KV pair in stream: {{reason;cleared}}, queued...
[+1555ms][CONN][INF] received special event '__reset', resetting dut
[+1555ms][SERI][INF] reset device using 'default' plugin...
[+1668ms][SERI][INF] waiting 1.00 sec after reset
[+2668ms][SERI][INF] wait for it...
[+3678ms][SERI][TXD] {{__sync;0}}
[+3689ms][CONN][RXD] mbedmbedmbedmbedmbedmbedmbedmbed
[+3689ms][CONN][INF] found KV pair in stream: {{__sync;0}}, queued...
[+3689ms][CONN][INF] found KV pair in stream: {{__version;1.3.0}}, queued...
[+3689ms][CONN][INF] found KV pair in stream: {{__timeout;90}}, queued...
[+3690ms][HTST][ERR] orphan event in main phase: {{__sync;0}}, timestamp=1736405062.078865
[+3690ms][HTST][ERR] orphan event in main phase: {{__version;1.3.0}}, timestamp=1736405062.078880
[+3690ms][HTST][ERR] orphan event in main phase: {{__timeout;90}}, timestamp=1736405062.078887
[+3700ms][CONN][INF] found KV pair in stream: {{__host_test_name;reset_reason}}, queued...
[+3700ms][CONN][INF] found KV pair in stream: {{ready;0000000a,0}}, queued...
[+3700ms][HTST][ERR] orphan event in main phase: {{__host_test_name;reset_reason}}, timestamp=1736405062.089897
[+3711ms][SERI][TXD] {{reason_raw;get}}
[+3721ms][CONN][INF] found KV pair in stream: {{reason_raw;04000000}}, queued...
[+3732ms][SERI][TXD] {{reason;get}}
[+3742ms][CONN][INF] found KV pair in stream: {{reason;1}}, queued...
[+3753ms][SERI][TXD] {{reason;clear}}
[+3763ms][CONN][INF] found KV pair in stream: {{reason;cleared}}, queued...
[+3764ms][HTST][INF] Skipping the WATCHDOG reset reason -- not supported.
[+3765ms][HTST][INF] __notify_complete(True)
[+3765ms][HTST][INF] __exit_event_queue received
[+3765ms][HTST][INF] test suite run finished after 3.40 sec...
[+3774ms][CONN][INF] received special event '__host_test_finished' value='True', finishing
[+3787ms][HTST][INF] CONN exited with code: 0
[+3787ms][HTST][INF] No events in queue
[+3787ms][HTST][INF] stopped consuming events
[+3787ms][HTST][INF] host test result() call skipped, received: True
[+3788ms][HTST][WRN] missing __exit event from DUT
[+3788ms][HTST][INF] calling blocking teardown()
[+3788ms][HTST][INF] teardown() finished
[+3788ms][HTST][INF] {{result;success}}